iPhone 6 Plus Lcd Light Not Working Solution Display Light Ways Jumper
iPhone 6 Plus Display Light Problem Repair Solution Ic Ways Jumper
Here’s solution for Apple iPhone 6 Plus in troubleshooting or repairing display light failure for both LCD and Display. The solution below shows the connection tracks of the iPhone 6 Plus light circuit connection. Just analyze how the connection flows and then you may get some hints where to start in troubleshooting.
Apple iPhone 6 Plus smartphone was launched in September 2014. The phone comes with a 5.50-inch touchscreen display with a resolution of 1080 pixels by 1920 pixels at a PPI of 401 pixels per inch.
The Apple iPhone 6 Plus is powered by Apple A8 processor and it comes with 1GB of RAM. The phone packs 16GB of internal storage cannot be expanded. As far as the cameras are concerned, the Apple iPhone 6 Plus packs a 8-megapixel primary camera on the rear and a 1.2-megapixel front shooter for selfies.
Please Note that we will edit these solutions or add new ones if found in this page at any time in the future. So feel free to come back any time on this page to stay up to date.
How to Make a Jumper in the Socket Display
Prepare a cable smooth and adjust the length that we will connect its tracks
Heat Tin with solder for attaching fine wires so that it will closely united.
Use a voltage tester to measure the jumper cables.
Tips & Warning
Make sure the jumper cables are connected properly so that it can deliver a good flow.
Make sure that the jumper cables are not connected directly with the other jumper cable.
The only hint of Mobilerdx on how to make a lane jumper socket on the Nokia 111. good luck
iPhone 6 Plus LCD Display IC Solution Jumper Problem Ways LCD Display Not Working